A little bit of progress tonight. Very cold in the garage but finished the front suspension entirely. I need to go run some errands tomorrow including getting the rotors honed to fit over the hubs.

Shout out to Keith from Fuel1 Injector Services for sending me some high quality injectors after my last fiasco that I had posted before.

Need to run the front brake lines, ABS harness and then install rear swaybar and watts link tomorrow!


CTS-V Two-piece rotors up front, there’s more clearance than what you see in the picture. The caliper was just loosely bolted into place, with it level with the upright, it had plenty of clearance. Going to head out to get the rotors honed in the morning...