Any of you know how to custom fab hard brake lines or how difficult it is?
I’ve run into an issue rebuilding my brake master cylinder and may have to purchase a master cylinder from a different model car. The internal rubber seals are worn out and there are not currently any replacements that I’m able to find. I can use a newer master cylinder from a newer Datsun Z car but the front and rear reservoirs are switched around. This would then require some brake line bending or fabrication to attach the hard brake lines to the correct location.
I’ve found kits online but I’m not sure how good they are or how difficult it is to fab up the lines.
Both of the lines I need are 6-8" long and would have at least 3-4 bends of 90-45 degrees each.