This is a platform for User Generated Content. G/O Media assumes no liability for content posted by Kinja users to this platform.

Got a little further

Made the footwell panels with 18ga steel, the plan is for everything in the passenger compartment to be finished in steel rather then aluminum.

Illustration for article titled Got a little further
Advertisement

Also finally made the crossbraces that will hold the steering column, though not sure how thats actually going to be done safely

Illustration for article titled Got a little further
Advertisement
Illustration for article titled Got a little further

Made the seat mounts with 1.5" .120 wall square tube cut diagonally, each cut produced 2 tabs. Still need to make the other side.

Illustration for article titled Got a little further
Illustration for article titled Got a little further
Advertisement

Got the car up on stands, still to do is triangulation around the engine bay. There is alot of room under the sump for bracing but not sure what will be effective/how it should tie into the engine mounts.

Illustration for article titled Got a little further
Advertisement
Illustration for article titled Got a little further

Share This Story

Get our newsletter