I bought a thing!

Figure it will help me make some better panels for the RX-4 project. Should reduce welding and filler too!

Here’s my learning piece.


I tightened up the holding screws for the anvil and the pieces came out better. I’m thinking the upper portion of the C frame could use some bracing, but other than that it’s not too bad for my purposes.

I think I need a shrinker and stretcher to rough out the shapes for the quarters though, then I can smooth with the wheel. I thought about building a buck for this project, but I really only need one set of skins.

Share This Story

Get our newsletter