It verks! (Boxositelock III: The Testinating)

Illustration for article titled It verks! (Boxositelock III: The Testinating)

Running a “benchy” boat at the moment... System says 7 hours print time, but I’ll run out of the starter pack of PLA they give you with the machine long before the print is done, especially since I used nearly 1/4 of it doing bed-leveling. But in any case I just wanted to see how she runs on a more complex print. So far, so good!

Advertisement
Illustration for article titled It verks! (Boxositelock III: The Testinating)
Illustration for article titled It verks! (Boxositelock III: The Testinating)

Share This Story

Get our newsletter