Took off the Chrome Rocker Spears on my Fiat 124 spider to finish up welding some new panels in behind the doors.

It looks just lovely behind the panel!

So....yah.... that’d definitely going to need to be cut out, and will require welding in a whole new panel.

On the plus side, I was able to weld in the 19ga sheet metal quite nicely. Had a couple needle-sized pinholes after I grinded down the excess, but had already returned the wire-welder to Home Depot, so I just filled those two holes with some JB-weld.


Don’t feel too bad for me, after all, it was already a sub-2200 lb car, now it’s even lighter!